VDO Cyclecomputing MC1.0 Manual de instrucciones descargar pdf (Pagina 19)

1.0

1.Mounting

1.1 Mounting cable sensor and magnet

Important: mount the sensor first, then mount the wired handlebar holder as described under 1.2

Check the following while mounting:

a.  Distance between the sensor and magnet: 1 to 5 mm

b.  When mounting the sensor on a suspension fork, don’t forget to allow extra length for the cable. WATCH OUT: cable may tear

step 1: Loosely attach the sensor on the fork leg with cable ties (do not tighten yet).

step 2: Mount the magnet on a spoke. Adjust the magnet to the marking on the sensor (distance 1-5 mm).

step 3: When adjustment has been done finalise mounting by tightening cable ties and clamping magnet.

P1+P2

1.2 Mounting wire and VDO “any-size” handlebar holder

step 1:  Run the cable up the fork, pass it around the brake cable from the already fixed sensor to the handlebar. 

Use the enclosed cable ties or duct tape. Spiral the wire around the brake cable (this has proven to be the best solution).

step 2:  position the holder on the handlebar.

step 3:  feed the fixing clamp through the slot below the holder socket, pass the clamp around the handlebar and tighten it with a small screw driver. 

Do not overtighten, the plastic screw might be damaged. Readjust the cable so that it will not be stretched during steering. 

Finally tighten the zip ties holding the sensor.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 36 37

Comentarios a estos manuales

Sin comentarios

VDO Cyclecomputing MC1.0 Manual de instrucciones Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios Para Bicicletas VDO Cyclecomputing MC1.0