VDO Cyclecomputing C2 Especificaciones descargar pdf (Pagina 58)

C2-6104A OPERATION MANUAL

Tally / GPIO connections are connected via a D25 socket:

13 12 11 10 9 8 7 6 5 4 3 2 1

5v TX+ RX+ GND TI8 TI7 TI6 TI5 TI4 TI3 TI2 TI1 GND

TX- RX- GND TO8 TO7 TO6 TO5 TO4 TO3 TO2 TO1 GND

25 24 23 22 21 20 19 18 17 16 15 14

Note that the TX+/- and RX+/- pins are duplicates of the RJ45 connector and

support RS-422/485, as per the TSL specification.

The RJ-45 connection is as shown below (as viewed from the rear):

Pin Function Direction

1 0v GND

2 0v GND

3 TX- OUT

4 RX+ IN

5 RX- IN

6 TX+ OUT

7 No connection

In all cases, the Tally output bits match the Tally input bits – e.g. when TI3 is pulled

low externally, the TO3 pulls low to match it. This allows daisy-chaining of units

together.

This sets up the mode that the Tally module runs in – and defines one of three

different ways that it can operate:

Tally

mode

Result

Disabled Tally I/O is disabled.

Normal Sets border colour of the window

according to which Tally input bits

are active (pulled low).

Presets Activates a preset according to

which Tally input bit is active

(pulled low).

Adjust tally

Tally mode [Normal]

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 103 104

Sin comentarios

Models	Document Type
Mosaic Pro5	User's Guide Zon Mosaic Pro5 User`s guide, 208 pages
Sonus Studio5	User Manual VirtualDJ User Guide [en] , 25 pages
Sonus5/2	User's Guide Zon Sonus5/2 User guide, 193 pages
Sonus519	Operations Instructions Zon Sonus519 Operating instructions, 21 pages

VDO Cyclecomputing C2 Especificaciones Pagina 58